York HIC4008B21S Engineering Manual page 48

OPTIONAL PARTS
After attaching the connecting cable to each
5
terminal, take it out to inside the false ceiling or
outside of the unit. Connect it to the IR receiver kit.
Refer to the "Installation and Maintenance Manual"
of the indoor unit for indoor unit wiring instruction.
When running the connecting cable, run it to the
installation position of the IR receiver kit through
the top of the fixing plate for the indoor unit. After
running the connecting cable, take the distance (from
4 inches to 8 inches (from 101mm to 203mm) from
the indoor unit under surface to the connecting cable
as shown in the figure at the right.
After running the connecting cable, clamp the extra
length of the connecting cable using the cable band
and store it inside the ceiling.
Attach the decorative panel.
6
Refer to the Installation Manual for the decorative panel.
After the installation work for the decorative panel is completed, attach the IR receiver kit.
7
(1) Take the connecting cable out from the corner of the decorative panel. Connect the wiring for the IR
receiver kit to the relay connector as shown below.
After connecting, cover the relay connector connection with the wiring cover, and attach the wiring
cover with the cable bands.
Connecting Cable
IR Receiver Kit
(2) Affix the band at the rear side of the IR receiver
kit onto the projection at the decorative panel
as shown in the figure at the right.
3-10
Decorative Panel
Corner
Connecting Cable
Indoor Unit
Wiring Connection
Relay
Cable Band
Connector
Wiring Cover
Cable Band
Projection
Band
Fixing Plate
Relay Connector
TC-17005-rev.1