HE-VA Auto-Controller AC-Lite - May 2016
2.3 Power supply
The system is powered via the three pole plug/connector.
2.4 Radar sensor
The radar sensor may be fitted either to the Multi-Seeder or to the tractor. For fitting
instructions please refer to the separate instruction leaflet ref. S/DC/500-10-511
provided.
Connecting a Multi-Seeder-mounted radar sensor:
Simply connect the radar sensor lead to the lead from the junction box
(3-way connector). Coil any excess lead near the junction box and secure
the lead from the sensor at regular intervals using the cable ties provided.
Connecting a tractor-mounted radar sensor:
Open the junction box and remove the sensor extension lead with the
3-way connector (fig. 4). Plug the hole to prevent water ingress.
Figure 4
Connect the extension lead to the sensor and route back to the Terminator junction
box. Where possible follow the existing wiring loom and secure at regular intervals
using the cable ties provided.
Remove the lid of the terminal box by squeezing the sides, cut off excess cable length
and connect the head unit lead as shown in figure 5.
8
Remove the radar
sensor lead