HE-VA Auto-Controller AC-Lite - May 2016
6.6 Set % Step for Rate Offset
This sets the amount by which the rate is
adjusted away from the target rate when you
press the RATE + or RATE - buttons.
1. Press and hold the Ha>0 button as you switch
the instrument on. The instrument is then in
programme mode 3 on channel 1.
2. The display will show a number indicating
the % step (5 - 25% in 5% increments) (fig. 18).
3. PRESS
to select the required % step.
4. Switch off and on again to resume normal
operating mode.
20
+ Switch On
3
Figure 17: Set % Rate Step
Figure 18: Change % Rate Step
2