Table of Contents
Advertisement
2.2 The 'Tractor Terminator' Assembly
Mount the pushbutton Cutout Switch in a convenient position using 2 self-tapping
screws.
Remove the lid of the terminal box by squeezing the sides and connect the head unit
lead as shown in figure 3 below.
The Terminator is not a waterproof enclosure. Locate it where it is afforded protection
from possible water ingress and for neatness e.g. behind a trim panel or console.
10-way connector
(RED wire)
Figure 3: Head unit connection
NOTE: The head unit receives its power supply via the junction box (see figure 1).
The power supply terminals in the Terminator are not used.
The circular (CPC) connector trails to the back of the tractor to connect with the 6-
metre extension lead going to the junction box.
to PL1
HE-VA Auto-Controller AC-Lite - May 2016
8-way connector
to PL2
(RED/BLUE wire)
7
Advertisement
Table of Contents
