Programme Functions And Fault Diagnosis; Programme (Cal) Modes 1 - 5 - HE-VA AC-LITE User Manual

9. Programme Functions and Fault Diagnosis

9.1 Programme (CAL) Modes 1 – 5
Some settings do not need to be accessed during normal operation, unless the system
is transferred to another implement. Those settings that need to be accessed during
normal operation are explained in the operators' section (sections 3 - 7) of the manual.
Mode 1
From normal
display mode,
Mode
select channel
Entry
and hold CAL
button
continuously
Channel -
selection
Channel 1
Speed Sensor
Factor
[7.78 mm/pulse]
(see section 4.3)
Channel 2 Implement Width
[4.0 m]
(see section 5.3)
Channel 3
-------
Channel 4 Seed calibration
factor
[0.01 kg/rev)
Channel 5 Low Fan Speed
Alarm
[2500rpm]
Channel 6 Hopper Level
Alarm
On / Off
[On]
*Note 1: Used to set the number of pulses the fan sensor sees for 1 revolution
HE-VA Auto-Controller AC-Lite - May 2016
Mode 2 Mode 3
(Product
calibration)
Press and hold Press and hold
CAL button for HA-0 button while
10 seconds switching
while switching instrument on
instrument on
Press CAL Press HA-0
button button
Simulated Rate selection
Speed (kg/ha)
[10 km/h]
Grand Total Thousand Grain
Area [ha] Weight [45]
Rate - % Step
------- [5%]
(see section 6.6)
Automatic Expected Weight
pre-start (0-9999 grams)
(see section 6.5)
[OFF]
[4500] Minimum Fwd
*see note 1 speed
(see section 6.5)
Pre-start time Calibration
[4 seconds] complete
(see section 6.5)
Mode 4 Mode 5
Press and Press and
hold RATE+ hold RATE-
button for 10 button for 10
seconds while seconds while
switching switching
instrument on instrument on
Press RATE+ Press RATE-
button button
Pulses / Cut Out Alarm
metering unit Speed
rev. [600] [2.00 km/h]
Response Shaft Conf
[1000] [Hop]
-------
Motor
Calibration
Speed
[35 rpm]
Fan PPR
[0.000]
*see note 1
Minimum
Metering
Speed
[3 rpm]
23