Cutout Alarm; Simulated Speed; Application Rate - Kg/Ha Or Seeds/M² - HE-VA AC-LITE User Manual

HE-VA Auto-Controller AC-Lite - May 2016
NOTE: The default pre-start time is 4 seconds, however it can be changed if required in Cal
Mode 2-Channel 6 (ref. section 9).

3.6 Cutout Alarm

If the forward speed exceeds 2km/h with the Multi-Seeder 'out of work', the instrument
will alarm by beeping and flashing 'C.out' every 5 seconds. The alarm will continue
until the implement is lowered into work. The forward speed at which this alarm is
displayed can be modified by entering Cal Mode 5 and adjusting the speed on Channel
1. If set to 8.00, then it will not alarm until above 8 km/h.

3.7 Simulated Speed

If there is a problem with the forward speed, or for testing, a 'Simulated Speed' can be
used on the instrument. To enable this, disconnect the speed sensor, enter Mode 2
and while on Channel 1, use the + and – buttons to set a simulated speed value. Once
the correct speed is selected, press the Ha->0 button, and the instrument will now use
this speed until it is next powered down.
3.8 Application Rate – kg/ha or seeds/m²
The system can display application rate in either kg/ha or seeds/m². To switch between
the two settings, enter Cal Mode 3 and switch between 'Rate' kg/ha or 'Pop' seeds/m²
on Channel 1. The Thousand Grain Weight for that seed can then be entered on
Channel 2.
12