Set Implement Width - HE-VA AC-LITE User Manual

HE-VA Auto-Controller AC-Lite - May 2016

5.3 Set Implement Width

1. Select the Area Total channel (
2. Press and hold the CAL button for 5 seconds.
The display will flash "tot.1", then "tot.2" then
show the programmed implement width (fig. 12).
Default width = 4 metres.
3. Continue holding the CAL button and PRESS
to select the digit/decimal point to change.
4. HOLD to change the digit (or move the
decimal point). Releasing the button selects
the next digit (fig. 13).
5. Release the CAL button to return to the
normal display mode.
16
).
Figure 12 : View Implement Width
Figure 13 : Change Implement Width