Labrie Pendpac WITTKE RETRO FL Maintenance Manual page 85

Figure 3-13 Packer blade ahead proximity switch
Testing Procedure:
1.
Empty all refuse from the body and set the engine to 1500 rpm.
2.
Initiate an Auto-Pack cycle and observe the 'home' position of the blade when the cycle
completes.
Adjust the Packer Blade Ahead Proximity Switch if:
• the packer blade stops before reaching the fully 'home' position; or
• the pack cylinders remain pressured up or abruptly bottom out at the 'home' position.
Adjustment Procedure:
1.
Move the packer blade to the half pack position, switch off the hydraulic pump, shut the engine
off and remove the key (see Lockout/Tagout Procedure on page 37).
N : (2/3 blade only!) The front edge of a 2/3 blade should be set 4 in. (10.16 cm) forward of the
OTE
wiper rubber.
Maintenance 75