Table of Contents
Advertisement
7. Question:
Why is my split point uneven?
Answer:
You may have used uneven pressure during the splitting process.
To correct an uneven point split, insert the Chuck into the Split-
ting Port and split both sides again. Repeat until the split sides
are equal.
8. Question:
Why does the drill bit back up into the Chuck during the
sharpening procedure?
Answer:
•
Your Chuck may be dirty. Follow the steps for cleaning the
chuck.
•
Your bit may have been loose in the Chuck. Make sure to
tighten adequately before sharpening.
9. Question:
When splitting, why don't I hear a grinding sound?
Answer:
The Chuck is not seated properly in the Splitting Port. The Chuck's
Sharpening Guide must line up with the Splitting Guide on the
top of the Split Point Port. Firmly and slowly push the Chuck into
the hole until you hear grinding.
10. Question:
Can I change a 135° drill bit into a 118° drill bit?
Answer:
While you can change the degree angle of any drill bit, they
will perform best when sharpened at the same angle they were
manufactured.
www.drilldoctor.com
27
Advertisement
Table of Contents
