Table of Contents
Advertisement
+
24
2 . Insert Chuck into Alignment Port
To adjust the Chisel and Relief Angles,
simply align the bit as usual with the
following adjustment:
To increase relief, insert the Chuck into
the Alignment Port so that the Align-
ment Guides (raised fins) are notched
into one of the slots towards the (+)
symbol. This will make a more aggres-
sive drill point.
To decrease relief, insert the Chuck
into the Alignment Port so that the
Alignment Guides (raised fins) are
notched into one of the slots towards
the (-) symbol. This will make a more
precise hole. Take care not to adjust
Relief too far as this will actually
–
cause the drill to lose all Relief and
118˚
3. Tighten Chuck, and sharpen
as usual
Refer to section "Sharpening the Bit"
for these Steps. Experiment with a few
different settings to find the one that
best suits your drill bits and applica-
tion. You may find it helpful to mark
this setting for future use.
therefore not drill a hole.
Each notch in the Alignment
Port is approximately a 10°
change in Chisel Angle.
www.drilldoctor.com
Advertisement
Table of Contents
