Advertisement
Trouble Shooting
Trouble Shooting
Summary
1
Algae ............................................................................................................... 5
1.1 Excessive algae growth in water tank...................................................... 5
2
General ........................................................................................................... 5
2.1 Machine has no power............................................................................. 5
3
Drive................................................................................................................ 5
3.1 Filmfeed out of order, dryer-fan is working .............................................. 5
3.2 Machine does not start automatically ...................................................... 5
3.3 Machine doesn't stop automatically......................................................... 5
3.4 Drive motor does not run ......................................................................... 5
3.5 Transport stops before film comes out, changing the cycle time............. 6
3.6 Processing time and developer temperature relation .............................. 6
3.7 Changing the transport speed ................................................................. 6
4
Developer Bath ............................................................................................... 7
4.1 No circulation in bath ............................................................................... 7
4.2 Developer temperature too high .............................................................. 7
4.3 Developer temperature too low................................................................ 8
4.4 Developer temperature too low, fixer temperature too high..................... 8
4.5 Removing the turning knob...................................................................... 8
4.6 Calibration of developer temperature ...................................................... 8
5
Film defects..................................................................................................... 8
5.1 Films will not dry ...................................................................................... 8
5.2 The film does not transport correctly ....................................................... 8
5.3 Scratches, pressure marks, dirt on film ................................................... 8
6
Replenishment ................................................................................................ 9
6.1 Replenishment pump does not pump or not sufficiently .......................... 9
6.2 Replenishment rates are too high or too low ........................................... 9
6.3 Adjust replenishment pump ..................................................................... 9
7
Dryer ............................................................................................................... 9
7.1 Dryer fan does not function or runs with reduced speed ......................... 9
8
Water............................................................................................................... 9
8.1 Rinsing water does not flow..................................................................... 9
8.2 Water tank overflows ............................................................................... 9
The main components (circuit board, pumps, motors) of the
processor are located underneath the tanks. To perform ser-
vice you must drain the tanks, remove all racks, turn proces-
sor on side and remove bottom panel.
4
Advertisement
