Port Settings; Setting Do Parameters - Huawei SmartLogger1000 User Manual

SmartLogger1000
User Manual
Error Code Troubleshooting Suggestion
1. Check whether the DNS server
0x200b
2. Check whether the domain
3. Check whether the network
0x406e Confirm the encryption mode and
port supported by the mailbox, and
check whether they are correctly
configured.
0xa003 Check whether the domain name
or IP address of the SMTP server
are correct.
0xa006 Check whether the user password
is correct.
0xe003 Configure the addresses for
sending and receiving emails
correctly.

7.10.4 Port Settings

7.10.4.1 Setting DO Parameters

The SmartLogger provides three DO ports, which support external router reset and the audible
and visual alarm for grounding faults.
Connecting a 3G Router over the DO Port
Considering the restrictions on the current that can pass through the DO port of the
SmartLogger, you need to determine the number of DO ports to be used for the control based
on the maximum power supply current of the 3G router (the maximum power supply current
can be calculated based on the maximum power consumption and DC power supply voltage).


Issue 12 (2019-01-15)
address is correct.
name or IP address of the
SMTP server are correct.
communication between the
SmartLogger and DNS is
normal.
When the power supply current is smaller than 1 A, use one DO port.
When the power supply current is larger than 1 A but smaller than 1.6 A, use two DO
ports.
Copyright © Huawei Technologies Co., Ltd.
Error Code Troubleshooting Suggestion
1. Try again later.
0x4016
2. Check whether the DNS server
address is correct.
3. Check whether the domain name
or IP address of the SMTP
server are correct.
1. Check whether the user name
0x8217
and password are correct.
2. Log in to the mailbox of the
email sender and start the SMTP
service.
3. Log in to the mailbox of the
email sender and start the
third-party client license code
function.
0xa005 Check whether the user name is
correct.
0xe002 No domain name or IP address is
configured for the SMTP server.
Configure the domain name and IP
correctly.
Other error Provide SmartLogger run logs and
codes contact Huawei technical support.
7 WebUI
230