Table of Contents
Advertisement
INTENDED USE _____________________________________________________________
The Nitrogen Inflation System is a pneumatic device designed to generate deoxygenated air for the purpose of
inflating vehicle tires.
INSTALLATION INSTRUCTIONS _______________________________________________
1. Unpack and remove unit from shipping carton and pallet.
2. Inspect the unit for any visible damage.
3. Make sure the installation location is free from explosion or fire hazard and is suitably ventilated,
otherwise, ventilate the area periodically during use of the equipment.
4. Connect an air supply line from the nitrogen system inlet port to your compressed air source. Be certain
there is at least 30 feet of plumbing with a minimum I.D. of 3/8" between the air compressor holding tank
and the inlet port of the nitrogen system. This distance is recommended to allow moist air to condense
before reaching the nitrogen system.
NOTE:
• The air supply line feeding your nitrogen system must not have an oiler or a regulator adjusted
below the nitrogen system's minimum required pressure. An oiler will send oil to the nitrogen
system which will prematurely plug the pre-filters.
• The nitrogen generator has a filter system that captures oil, water and other contaminants.
However, if your air supply system generates an excessive amount of water, etc., it may be
desirable to install an air dryer.
• The air supply should be 125 psi (8.6 bar) minimum.
________________________________________________________________________
The presence of any oil in the Nitrogen Membrane will void the
________________________________________________________________________
NOTICE:
manufacturer's warranty.
4
Hide quick links:
Advertisement
Table of Contents
