Page 1
MODEL 5500 Installation, Operation Tire Repair and Repair Parts Station Information Branick Industries, Inc. • 4245 Main Ave • Fargo, North Dakota 58103 P/N: 81-0047H REV08312017...
TABLE OF CONTENTS _______________________________________________________ SAFETY INSTRUCTIONS DEFINITIONS INSTALLATION INSTRUCTIONS OPERATING INSTRUCTIONS MAINTENANCE INSTRUCTIONS REPAIR PARTS WARRANTY SAFETY INSTRUCTIONS _____________________________________________________ ▪ NEVER allow unauthorized personnel to operate this product. ▪ NEVER use this product for anything other than its intended use. ▪...
Page 3
Tighten nylon lock nuts enough to allow free rotation at pivot points (see page 3). 2) Position the Model 5500 on a solid level floor leaving a minimum of 36 inches of clearance on operation sides and 24 inches of clearance on tool tray side.
SPREAD CYLINDER ITEM PART NO. DESCRIPTION 950-194 SPREAD CYLINDER HOUSING 950-195 PISTON ROD ASSEMBLY 098-327 COVER PLATE 108-038 7/16 WASHER 028-005 7/16-14 x 3/4 SCREW 041-202 ROD SEAL 61-0028 QUAD RING SEAL 11-0065 NYLON WEAR STRIP LIFT CYLINDER ITEM PART NO. DESCRIPTION 01-0181 END COVER...
During the warranty period, at the discretion of Branick management, if the product is found to be defective, it will be repaired or replaced without charge. For service, contact Branick (800-437-4394) to obtain an RMA. Any product shipped to Branick must have an RMA and proof of original shipment date.