OHIO WILLOW WOOD LimbLogic VS Series Prosthetist's Manual page 22

Problem
The green LED on
the charger node does
not illuminate or blink
when the charger is
plugged into vacuum
pump and AC outlet.
Action
• Make sure that the green marks on the
charging port and the charging plug are
aligned (page 9). Do not force the
connection.
• The pins on the charger plug may be bent.
Unplug the charger from the vacuum
pump and inspect the pins. Do NOT try to
straighten pins while charger is plugged into
an AC outlet! If the pins are bent or broken,
contact Ohio Willow Wood.
• With the charger plugged into an AC outlet
and the pump, press and hold the reset button
on the charger node for 5 seconds, then
release. If the green LED does not blink or
turn solid within 5 seconds after the button
release, contact Ohio Willow Wood.
• If charger plug pins have been bent or the
plug has been forced into pump, the internal
electronics of the pump can be damaged,
or the green LED on the charger could be
damaged. Use the fob to check the pump
battery level, then charge the pump for
2 hours and re-check the battery level to
verify that the level has increased. If the
level has not increased, contact Ohio
Willow Wood.
22
continued on next page