Pin Assignment Of The Male Multipoint Connector; Pin Assignment Of The D-Sub Socket On The Front Panel - REXROTH VT-HACD-DPQ Series Technical Data Manual

8/10 VT-HACD-DPQ | Digital control electronics
Technical data (continued)
Card dimensions
Front plate dimensions:
Height
Width soldering side
Width component side
Admissible operating temperature range
Storage temperature range
Weight

Pin assignment of the male multipoint connector

Pin Row z
2 n.c.
4 n.c.
6 n.c.
8 n.c.
10 n.c.
12 Shield
14 n.c.
16 n.c.
18 n.c.
20 System earth
22 DO3: Back pressure
24 DO4: Injection
26 DO5: Retraction completed AO3: Valve output
28 DO6: Injection position
30 UB: +24 V
32 LO: 0 V
1) By means of software, the inputs can be set to 0...10 V, ±10 V,
0...20 mA or 4...20 mA.
2)
By means of software, output AO1 can be set to 0...10 V, ±10 V
or 4...20 mA.

Pin assignment of the D-Sub socket on the front panel

Bosch Rexroth AG, RE 30146, edition: 2013-10
Row b
AI3+: Internal mold pressure 1)
AI3–: Internal mold pressure 1)
AI2+: Actual pressure value FB 1
AI2–: Actual pressure value FB 1
AI1+: Pressure command value
AI1–: Pressure command value
AI4+: Actual pressure value FB 2
AI4–: Actual pressure value FB 2
AI5+: Analog cyl. position 1)
AI5–: Analog cyl. position 1)
AI6+: Velocity command value
AI6–: Velocity command value
Analog GND
–10 V
+10 V
5
9
6
1
Euro-card 100 x 160 mm, DIN 41494
3 HE (128.4 mm)
1 TE (5.08 mm)
7 TE
 0 to 50 °C
 –20 to +70 °C
m 0.2 kg
Row d
DI1: Back pressure
DI2: Auto
1) DI3: Start holding pressure
1)
DI4: Injection/jog+
1) 3)
DI5: Incremental home
1) 3) DI6: Post-retraction/jog-
1) DI7: Analog injection
1) DI8: Analog command value
Enable
DO1: Actual velocity profi le
1) Card OK.
1) Data+: Local bus
DO2: Signal error
Data-: Local bus
AO1: Valve output 1 2)
AO2: Valve output 2
3)
This input has an input resistance of R
n.c. ... not used in basic version, however reserved for extensions.
GND
Transmission data (RS232)
Reception data (RS232)
Row f
DO7: Pressure
SSI clock+
SSI clock–
SSI data+; inc. Ua1
SSI data–; inc. /Ua1
Inc. Ua2
/inc. Ua2
Inc. Ua0
/inc. Ua0
n.c.
n.c.
n.c.
n.c.
CAN Gnd
CAN L
CAN H
> 10 MΩ
i