Equipment Configuration
The communication tester is set according to the WISMO228 operating mode. Paging during idle
modes, TX burst power, RF band and GSM/DCS/GPRS may be selected on the communication
tester.
Refer to the following table for the network analyzer configuration according to operating mode.
Operating Mode
OFF Mode
Alarm Mode
Idle Mode
Connected Mode
Transfer Mode class 8
(4Rx/1Tx)
GPRS
Transfer Mode class 10
WA_DEV_W228_PTS_002
Table 43. Operating Mode Information
Communication Tester Configuration
N/A
N/A
Paging 2 (Rx burst occurrence ~0,5s)
Paging 9 (Rx burst occurrence ~2s)
850 MHz
900 MHz
1800MHz
1900 MHz
850 MHz
900 MHz
1800MHz
1900 MHz
850 MHz
Rev 001
Product Technical Specification &
Customer Design Guidelines
PCL5 (TX power 33dBm)
PCL19 (TX power 5dBm)
PCL5 (TX power 33dBm)
PCL19 (TX power 5dBm)
PCL0 (TX power 30dBm)
PCL15 (TX power 0dBm)
PCL0 (TX power 30dBm)
PCL15 (TX power 0dBm)
Gam.3 (TX power 33dBm)
Gam.17 (TX power 5dBm)
Gam.3 (TX power 33dBm)
Gam.17 (TX power 5dBm)
Gam.3 (TX power 30dBm)
Gam.18 (TX power 0dBm)
Gam.3 (TX power 30dBm)
Gam.18 (TX power 0dBm)
Gam.3 (TX power 33dBm)
Page 93 of 108