6
7
8
9
Disconnecting the cable harness in the base
1
Product manual - IRB 8700
3HAC052853-001 Revision: F
Action
Cut the cable tie located underneath the
axis-4 motor.
Unscrew the screws that secure the cover.
Remove the cover.
Use caution and remove the cable harness
out of the upper arm.
Action
DANGER
Make sure that all supplies for electrical
power, hydraulic pressure, and air pressure
are turned off.
© Copyright 2015-2018 ABB. All rights reserved.
4.4.1 Removing the cable harness
Note
xx1500002721
xx1500002722
xx1500002723
Note
Continues on next page
4 Repair
Continued
207