Ratchet Belt; Toe Clips; Check-Out - Sunrise Medical Quickie Match Point Owner's Manual

E N G L I S H
M. RATCHET BELT
1. Connect two belt halves together with bolt, washers (one on the top, one on the bottom, and 2
in between), and nut (Items 1, 2, & 3 Detail A). Do not over tighten.
2. Attach ratchet positioning belt bracket (Item 4) on top of seat sling using the existing screws that
came with the chair (Detail B). Torque screws on seat sling to 45 inch-lbs (5 N-m).
3. Attach belt to bracket with bolt and nut (Items 1 & 3 Detail B). Belt can be attached to inside or
outside of bracket.
4. Repeat for other side.
N. TOE CLIPS
1. Attach plastic toe clips to the front of the toe clip bracket (A) in desired hole position using
screws, washers (one on each side), and nuts (as shown).
2. Unscrew footplate (B) from footrest clamp (C), save screws and nuts.
3. Attach toe clip strap (D) to the bottom side of the footplate using screw, washer, and nut
(as shown).
4. Reattach the footplate (B) to the footrest clamp (C) with toe clip bracket (A) in between using the
screws and nuts saved from step 2.
5. Loop the toe clip strap through the toe clips.
O. CHECK-OUT
After the wheelchair is assembled and adjusted, it should roll smoothly and easily. All accessories should
also perform smoothly. If you have any problems, follow these procedures:
1. Review assembly and adjustment sections to make sure chair was properly prepared.
2. Review troubleshooting guide.
3. If your problem persists, contact your authorized Quickie supplier. If you still have a problem after
contacting your authorized Quickie supplier, contact Sunrise Medical customer service. See the
introduction page for details on how to contact your authorized Quickie supplier or Sunrise
Medical customer service.
Ratchet Belt (Optional)
Ratchet Belt– Detail A
Ratchet Belt– Detail B
Toe Clips (Optional)
17
A
B
3
1
2
1
3
4
B
D
A
C
930494 Rev. A