Briggs & Stratton Commercial Series Operator's Manual page 18

18
Wash the Mower Deck (if equipped)
Note:
Use the washout port (C, Figure 19) to clean the underside of
the mower deck.
1. Place the rider on a smooth level surface.
2. Attach the quick disconnect (A, Figure 19) to the garden
hose (B) and then connect to the washout port (C) on the
mower deck.
3. Turn the water on.
4. Sit in the seat and start the engine.
5. Set the Height-of-Cut in the highest position.
6. Engage the Power Take-Off (PTO) switch to activate the
mower blades. The rotation of the blades and the running
water will clean the underside of the mower deck.
7. Disengage the Power Take-Off and stop the engine.
8. Remove the garden hose and quick disconnect from the
washout port (C).
18
19
Push the Rider by Hand
To push the rider, perform the following:
1. Disengage the Power Take-Off (PTO) (A, Figure 20).