Operation - Bartscher MultiTherm Instruction Manual

WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label). Connect the device only in case of compliance!
The device must only be connected to a properly installed single socket with
protective contact.
Never remove the power cable by pulling the cable itself; always grab the plug
housing.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.

5.3 Operation

•
Before using the device, clean it in accordance with the instructions contained in
6.2 „Cleaning".
•
Turn the temperature control with the red dot all the way to the left.
•
Plug the power plug into the socket (the green control lamp lights up).
CAUTION!
It is important that there is always drinkable liquid in the container before
engaging the device. You must not pour undrinkable liquids such as acids,
bases or leys, oils, nitrates etc. in the mulled wine pot.
•
Pour the desired drinkable liquid in the mulled wine pot.
Minimum filling quantity of 2 litres.
WARNING!
During operation it must be ensured that no liquids can spill over as this can
cause short-circuits in the electronic control. Personal injury can be the result.
•
The temperature control is infinitely variable between approx. 30 ° C - 90 ° C.
- 24 -