Example Of Tower Installation - Huawei iSiteC BTS3601C Installation Manual

Installation Manual
iSiteC BTS3601C CDMA Base Station
1) Cabling rack for feeder
5) ODU3601C
Figure 2-7 Directional BTS3601C installation on metal masts
IV. Note
First determine the mast on which the BTS3601C is to be installed during the
l
planning.
For antenna jumper and feeder routed vertically, bind them on the metal masts
l
with the spacing of 30cm via black cable ties; for antenna feeder routed along the
cabling rack, fix them with the spacing of 1m or 2m via feeder clips.
Power cables from BTS3601C to ODU3601C should be protected by metal tubes,
l
and fibers for cascading by currgated tube. Power cables and fibers routed
vertically should be bound on the metal masts via black cable ties, and those
routed horizontally should be bound to the cabling rack.
Power cables should be distributed along the outer side of the cabling rack, and far
l
away from the fibers and feeders.

2.2.5 Example of Tower Installation

This mode is applied to such locations as fields, villages, towns, and roadsides to cover
villages, roads, etc. In this mode, the hoisting of BTS3601C is involved.
2) IAFB 3) BTS3601C
6) Directional antenna 7) GPS antenna
2-11
Hardware Installation
2 Installing Cabinet Hardware
4) AC lightning protection box