Installation In A Sliding Sash Window - Gree GPC12AL-K5NNA3A Service Manual

5. Close the window sash securely against the Window panel.(As show in Fig.19)
6. Stuff the sponge B between the glass and the window to prevent air and insectsfrom getting into the room.(As show in Fig.20)
Fig.19
7. Attach the bracket with a screw.(Recommended)(As show in Fig.21)
Please lay a tabular material underneath the window panel in case you could not attach the rain guard or the window adapter properly
due to the deep window sill.

9.4 Installation in a sliding sash window

1.Connect the rain guards to the insect guard net.(As show in Fig.22)
Insert all three projections on each rain guard into the holes in the insect guard net.
Side "A" will now be at the top, as indicated in the diagram.
2.Attach the guard combined above to the window panel. (As show in Fig.23)
3XVK WKH LQVHFW JXDUG QHW ¿UPO\ WR HQVXUH WKDW LWV IRXU SURMHFWLRQV ¿W LQWR WKH KROHV LQ WKH ZLQGRZ SDQHO
Side "A" will now be at the top, as indicated in the diagram, when it is installed in the window.
Insect guard net
Hole
Projection
3. Cut the foam seal A (adhesive type) to the proper length and attach it to the window frame.(As show in Fig.24)
4. Install the window panel into the window frame.(As show in Fig.25)
Make sure that the exhaust cover is attached to the window panel.
Inner height of the window:20.5"(520mm)
Use the window panel.
The window panel cannot be installed in windows less than 20.5" (520mm) high, as you will be unable to shut the exhaust
cover.(As show in Fig.26)
(1) Open the window sash and place the window panel on the window frame.
(2) Secure the window panel to the window frame with 2 screws.
Fig.24
44
"A"
Fig.22
Rain guard
Foam seal A
Bracket
Fig.21
Projection
Exhaust cover
Window panel
Cut
Fig.25
Fig.20
Window panel
"A"
Fig.23
Fig.26
Service Manual
20.5"
Maintenance