Recording On Cdr; Recording A Cd To Cd-R Or Cd-Rw Disc - Sony RCD-W1 Operating Instructions (primary manual) Operating Instructions Manual

Recording on CDR

Recording a CD to CD-R or
CD-RW disc
(Synchro-Recording)
You can easily make digital recordings from a
CD to a CD-R, or CD-RW, making track
numbers in the same sequence as the original
CD.
Before recording, see "Notes" on page 17.
After recording, you must finalize the disc.
Until the disc is properly finalized, it cannot be
played on any other machine. See "Finalizing
CD-R and CD-RW discs" on page 20.
CD SYNCHRO NORMAL
1
Press POWER.
2
Press A of DECK B and place a
recordable CD-R or CD-RW on the disc
tray. Press A of DECK B again to close
the disc tray.
With the label side up
3
4
5
To stop recording
Press x.
Notes
CD SYNCHRO
• When copying a disc digitally recorded under
NORMAL
• When copying a commercial music CD contains
• You cannot monitor the sound being recorded
"TOC" starts to flash. The recorder starts to
read the TOC (Table of Contents) data and
shows the type of the disc in the deck on the
front panel display.
When you place a CD-RW in the deck, the
recorder optimizes itself for the best
possible recording and "OPC" appears on
the display shortly.
Press A of DECK A and place a CD on
the disc tray. Press A of DECK A again
to close the disc tray.
Press CD SYNCHRO NORMAL. "CD
SYNCHRO" appears and "REC" flashes
in the front panel display. DECK B
stands by for recording, and DECK A
stands by for playing.
Press H on the front panel or on the
remote to start recording.
Recording starts. DECK A and DECK B
will automatically stop after recording.
control of the Serial Copy Management System
(SCMS), the recorder automatically select the
analog recording. For detailed explanation on
SCMS, refer to the "Notes" on page 18.
copy-prohibit signals, the recorder automatically
select the analog recording.
during recording. When you want to monitor the
sound when you are recording, change the source
selector of the amplifier to DECK A, or use a
headphone.
15