Before First Use - Krups XP56 Series Manual

n To prolong the life of your appliance, we recommend you use a Claris Aqua Filter System F088 cartridge
(accessory not included) and that you descale the appliance at regular intervals.
IMPORTANT!
Before using for the first time, after a prolonged period of inactivity or after descaling,
the appliance must be cleaned as described in paragraph 5: "BEFORE FIRST USE".

4. BEFORE FIRST USE

Before using your espresso machine, clean all the accessories in soapy water and dry them.
If you are not using the Claris cartridge, please refer to the paragraph here below "RINSING OF YOUR
APPLIANCE".
A. INSTALLING THE CLARIS CARTRIDGE (to be done every time the cartridge is replaced)
If you are using a Claris filter cartridge, please follow the procedure to fill it with water:
n Screw the Claris filter into the bottom of the water tank.
n Fill the water tank with water and put it back in place (fig.2 and 3).
n Turn the appliance on by pressing the "
n Turn the switch to the "
position.
n Repeat this operation 2 more times.
n To make sure the Claris cartridge is full of water, place a container under the brewing head, turn the
switch to the " " position and make sure some water is running through. If not, repeat the above
procedure.
n In this manner you can be sure that water is circulating well through the filter cartridge.
IMPORTANT:
This installation procedure must be carried out every time the cartridge is replaced.
The Claris cartridge needs to be replaced every 2 to 3 months if it is used daily.
B. RINSING YOUR APPLIANCE (to be done on first use and after each cleaning / descaling
operation)
- RINSING OUT THE ESPRESSO CIRCUIT
Before making an espresso for the first time, the machine should be cleaned.
n Open the lid and remove the water tank using the handle (fig.1).
n Fill it with water (fig. 2).
n Put the water tank back in place by positioning it firmly, to ensure the water inlet is in place, and close
the lid (fig.3).
n Turn the appliance on by pressing the "
n Insert the filter holder (without ground coffee) in the appliance (fig.7).
n Place a container of sufficient volume under the filter holder.
n Once the appliance has reached the right temperature, the light stops flashing. Turn the switch to the
" " position (fig.8) and let all the water in the tank run through.
n If necessary, stop the operation by turning the switch to the "
and then resume the operation.
n Empty the container and unlock the filter holder: press the "OPEN" button on the filter holder and turn
it to the left (fig.10).
" button (fig.4).
" position. Once the light stops flashing, turn back the switch to the "
" button (fig.4).
" position (fig.9) to empty the container
English
"
4