L-Card L-502-P-G-D-I User Manual page 10

10
Characteristics
The amount of user area of
Flash-memory
JTAG port to adjust the
embedded software
The possibility of custom low-
level programming
Independent software access to
the memory of the signal
processor
DMA in PCI BUS MASTER
mode
Interface
Synchronization:
- External data collection start
- External frequency of ADC
conversion
- From the next module
- Analogous
The technology of the basic
interface element
Indication on the panel
The possibility of remote
firmware update FPGA
Program activation of pull-up
resistors of digital inputs
Independent resolution of the
active state of the digital output
of the low and high byte
Full list of L-502 characteristics –
Already today, the architecture of the L-502 is not limited to just this one project by L-Card
LLC. The new
!
L-502: Only the interface with the PC with the same functionality as the L-502 was subjected
to processing, except for small functional differences. The E-502 and L-502 software also
has continuity (common library functions of the upper software level of the PC, identical to
the software at the Blackfin level).
L-502
1 MB
Yes
[P]
Yes
Yes
[P]
Yes
PCIe x1
Yes
Yes
Yes
Yes
FPGA
Altera Cyclone IV
Yes
Yes
Yes
Yes
Chapter 5
E-502 with USB and Internet interfaces has a continuity of architecture with
L-780(М)
32 bytes
No
Yes
Yes
No
Yes
No
No
Yes
PLX Tech.
PLX9050/9030
No
No
No
No
49
on page .
General description.
L-783(М)
32 bytes
No
Yes
Yes
No
PCI 32 bit, slot 5V
Yes
No
No
Yes
PLX Tech.
PLX9050/9030
No
No
No
No
L-791
64 Kbyte
No
No
No
Yes
Yes
No
No
No
FPGA
Altera
Acex1K
No
Yes
No
No