HP 200 Series Hardware Support Document page 38

30
Removal and Replacement
3. Pull the rear edge of the cover up about 75 mm (3 inches), then straight back about 10 mm
(114 inch).
4. Pull the cover straight up and off.
5. If a late production version, lift the front of the RFI shield and remove
it
from the computer.
Removing the Top Cover
Tore-install the top cover, follow this procedure:
1. If a late production version, install the RFI shield.
Installing the RFI Shield
2. Hold the top cover at a 45° angle and place the front edge of it underneath the top surface of
the front cover.
3. Push the cover down while pressing it forward.
4. Reinstall the two screws in the rear panel.