Table of Contents
Advertisement
18 . Spotlight 200 User's Guide
Location and Ventilation
The Spotlight 200 is installed by a PerkinElmer Service Engineer, who will be able to advise
on the positioning of the system. To allow for adequate cooling, the system should not be
sited near to room heating equipment, for example, central-heating radiators. There should
be a minimum gap of at least 15 cm (6 inches) from the top and side surfaces of the
microscope and stage control box to permit adequate cooling.
Make sure that the switches at the electrical supply inlet at the rear of
the microscope and stage controller are not obstructed.
WARNING
Advertisement
Table of Contents
