Panasonic CS-Z25UD3EAW Service Manual page 43

Installation into the Ceiling

Attach the nuts and washers to the hanging bolts, then lift up and hook the main unit onto the hanging fixtures.

Check if the unit is leveled using a level or a vinyl hose filled partially with water.
Remote Controller Installation
1 Remove the remote controller 1 lower case.
(Insert a flat-tipped screw driver or similar tool
2 to 3 mm into one of the gaps at the bottom
of the case, and twist to open. Refer to the
illustration at right.) Be careful not to damage
the lower case.
2 Do not remove the protective tape which is
affixed to the upper case circuit board when
remove the remote controller lower case.
3 Secure the lower case to an outlet box or wall.
Refer to (A) or (B) instructions below
depending on your choice of cable installation.
4 Be sure to use only the screws provided.
5 Do not over tighten the screws, as it may
result in damage to the lower case.
6 Connect the indoor unit and the remote
controller 1. (Refer to the illustration)
7 Insert firmly the connector of remote controller
cable 2 to connector at control box of indoor
unit.
8 Fix the green wire from remote controller
cable 2 to the grounding location provided
inside control board.
Flat
washer
5
Level
43
Hanging bolt (M10)
(locally purchased)
Hexagonal nut (M10)
(locally purchased)
Upper case
Screw
driver
Gaps
Lower
case
Screws
or Screws
Control box
Connector
3
4
2
Remote controller cable
1
Remote controller