Welch Allyn MICROTYMP 4 User Manual page 50

Welch Allyn MicroTymp® 4 Tympanometer User Manual
CONFIGURATION
(SWEEP SETTINGS)
CONFIGURATION
(REFLEX SETTINGS)
CONFIGURATION
(SYSTEM SETTINGS)
DIR 80024157 Ver A
TEST SEQUENCE
EAR SEAL CHECK
RELOAD DEFAULTS
REFLEX LEVELS
REFLEX FREQUENCIES Selectable from 500, 1000, 2000 and 4000
REFLEX SELECTION
REFLEX THRESHOLD
REFLEX AUTO-STOP
REFLEX POLARITY
REFLEX FILTER
RELOAD DEFAULTS
SET DATE/TIME
POWER-OFF DELAY
progress. Graphical displays are shown
automatically at the end.
Select the test order for a both-ear test -
left then right or right then left.
Select STANDARD or EXTENDED.
The options in this group are reset to their
default values
Select the maximum tone level and step
size to be used for the reflex test. Default
is 95dBHL with 5dB steps.
Hz.
ALWAYS MEASURE
NEVER MEASURE
ONLY IF PEAK FOUND
PROMPT TO MEASURE
Default is 0.03 ml
Default is YES.
Choose whether a reflex trace is shown
ascending (UP) or descending (DOWN).
Select either 2 Hz or 1.5 Hz.
The options in this group are reset to their
default values.
Set the internal clock date and time.
The time before the unit turns off
automatically if no key is pressed. Select 90
or 180 seconds.
Page 37