Configuration - Welch Allyn MICROTYMP 4 User Manual

Welch Allyn MicroTymp® 4 Tympanometer User Manual
Press the down ▼ navigation keys to scroll through the menu until CONFIGURATION is
highlighted and then press the right navigation key ► to select.
C
ONFIGURATION
The configuration menu contains 17 items with the values and defaults indicated in the table
below. Select and change the items as necessary to set up your device before you begin testing.
The settings are retained in memory after the unit is turned off.
Configuration Item
(Sweep Settings)
Test Sequence
Ear Seal Check
Reload Defaults
(Sweep Settings)
Configuration Item
(Reflex Settings)
Reflex Levels
Reflex Frequencies
Reflex Selection
Reflex Threshold
Reflex Auto Stop
DIR 80024157 Ver A
Value Options
Both: L, R
Both: R, L
Standard or Extended
Yes or No
Value Options
100 dB/10 dB Steps
100 dB/5 dB Steps
95 dB/5 dB Steps
90 dB/5 dB Steps
85 dB/5 dB Steps
500 Hz, 1k, 2k, & 4kHz (individually
selectable)
Always Measure
Never Measure
Only If Peak Found
Prompt To Measure
0.01 to 0.5 ml
Yes or No
Default Value
Both: R, L
Standard
No
Default Value
95 dB/5 dB steps
1 kHz
Only if Peak Found
0.03 (ml)
Yes
Page 10