Brother PR-620 Tips And Techniques page 7

Tips and Techniques on the PR-620
6.Using the disk shaped screwdriver, firmly
tighten the screw.
Check the embroidery area
1. Touch
about to move, select
2. Touch
showing the embroidery area for the pattern
are indicated by needle punch points.
3. Carefully watch the movement of the embroidery frame and check that
the embroidery frame does not hit the presser foot.
4. When the embroidery frame moves to the desired position, touch
again.
5. To continue moving the embroidery frame, touch
the embroidery area, touch
Finding the sewing position
TIP:
By locking the needle bar and presser foot in the down position,
the needle drop point can easily be easily seen.
1. Hold the needle clap that is at the sewing position, and
then fully lower the needle.
2. The needle and presser foot are locked into the down
position.
3. Touch the arrow keys in the embroidery settings screen to move the
embroidery frame so that the needle drop point is at
the center of the area you wish to embroider.
, a message appears warning that the embroidery frame is
.
again. The corners of the octagon
.
. To stop checking