XDynamics EVOLVE User Manual page 56

Remote Controller Application
Linking the Remote Controller
The Evolve drone system is pre linked from the factory. If there becomes a situation requiring the
Remote Controller and the drone to be re-linked Follow the below steps:
To pair the remote controller to a new drone follow these steps:
1. Navigate to the Smart Pilot System Drone Pairing Page.
2. Turn on the Drone.
3. Keep the Drone at least 3ft away from the Remote Controller.
4. Tap "Start Pairing" on the Remote Controller screen.
5. Follow the instructions on screen to complete the pairing.
6. The screen shows the modules pairing status.
7. The whole pairing process may take up to 2 minutes.
Only required if trying to pair a new drone to the remote controller or a new controller to the
drone.
Evolve User Manual V1.0 by XDynamics Limited 56