XDynamics EVOLVE User Manual page 24

Determining the Return to Home Altitude
Depending on the flight conditions and obstacles in the return to home flight path, the operator can
choose a safe return altitude for the Return to Home function. This altitude should be set up before
flight under the APP configuration tab. A low altitude setting is not recommended for obstacle
clearance (such as tress or buildings). Also notice the maximum legal flight altitude. This configuration
allows the drone to reach a programed altitude before starting to flying back to the home position. If
the drone is below the programed altitude it will climb to the programmed altitude then proceed to
the home position. If the drone is above the programed altitude it will remain at that altitude and then
proceed to home position.
Note: This altitude setting is also used for Return to Home function in a case of failsafe
triggering do to loss of signal or power loss of controller.
To configure the Return to Home Altitude, user may enter the Setting Page. At the Drone section, there
is the RTH Altitude Setting, tap and change the value.
Evolve User Manual V1.0 by XDynamics Limited 24