Fisher & Paykel HD30 Installation Instructions Manual page 19

Hide thumbs Also See for HD30:

Table of Contents

Fig.19

Downdraft Unit Remote Blower Electrical Connection

• Connect the power supply cable into the box as described in the 'Downdraft unit internal blower

electrical connection' section (above).

• To use a remote blower, install a control cable between the downdraft unit and the remote blower. See

the 'Remote blower electrical connection' on next page.

• Additional knock outs should be used for the remote blower wiring.

• Install a suitable UL listed strain relief or conduit fitting (not included) into the knock out.

• Connect the remote blower wiring into the downdraft unit: N (neutral) into the right terminal, L1 (live)

into the left terminal and the green (ground) wire goes into the ground terminal Fig.20.

• Ensure that the terminal screws are tightly holding all wires in place.

• The remote blower will be connected to the additional control cable

• Replace the cover of the terminal box Fig.18.

https://producthelp.fisherpaykel.com/us/Cook/Ventilation/Downdraft/HD36/User_Guide_HD36/05_installation_instructions

Fig.20

Updated: Fri, 28 Jun 2019 03:30:59 GMT

Table of Contents

Hd36