Remove The Downdraft From The Cabinet - Fisher & Paykel HD30 Installation Instructions Manual

Hide thumbs Also See for HD30:

Table of Contents

Failure to follow these instructions could result in damage to the countertop surface.

• Level and align the downdraft unit in the cabinet. Push the support leg mounting bracket on each side down

against the cabinet floor. Mark the top edge of the mounting bracket on the downdraft unit and the mounting

holes on the cabinet floor Fig.6.

4. Remove the Downdraft from the Cabinet

• Remove the screws from the countertop and lift the downdraft unit back out of the cabinet.

• Pre-drill the marked mounting holes in the cabinet floor.

• Tighten the support leg mounting brackets on the unit at the pre-marked positions.

• Place the downdraft unit on a flat protected surface to prevent damage in order to install the blower.

https://producthelp.fisherpaykel.com/us/Cook/Ventilation/Downdraft/HD36/User_Guide_HD36/05_installation_instructions

Fig.5

Fig.6

Updated: Fri, 28 Jun 2019 03:30:59 GMT

Table of Contents

Hd36