Set Up Position Feedback Page - ABB COMMANDER 300 Programming Manual

...4 CONFIGURATION

4.7 Set Up Position Feedback Page

Information.
• This page is only present if
Up Control Page – see Fig. 3.1 and Section 4.10. If
Feedback Enable must be set to
• Millivolt, current, voltage or resistance input.
• Programmable fault level and actions.
SEtUP
PSN–Fb
IntYP3
MVLt
MAMP
VOLt
ohM
r–HI–3
135.0
dEC–Pt
135.0
r–LO–3
0.0
bSPd– 3
NONE
UP
dN
FdLP–3
10.0
22
or
P–PrOP bndLSS
to enable access to this page.
INdCtN
Page Header – Set Up Position Feedback.
Position Feedback Input Type
Select the input type required:
–
MVLt
–
MAMP
–
VOLt
–
ohM
Position Feedback Range Full Scale
Set the position feedback range full scale value, within the
limits of
Table 4.2
Decimal Point Position
Set the decimal point position required for both the position
feedback range full scale and range zero values.
Position Feedback Range Zero
Set the position feedback range zero value, within the
limits of
Table 4.2
Broken Sensor Protection Drive
In the event of a fault being detected on the input, the
remote set point is driven in the direction of the mode
selected.
Select the broken sensor drive required:
drive, for upscale drive or
UP
Fault Detection Level Percentage, Position Feedback
Input
A fault level percentage can be set to detect a deviation
above or below the display limits, e.g. If set to 10.0%, then
if the position feedback input deviates by more than 10%
above Full Scale value or 10% below zero value, a fault is
detected. Position feedback action in the event of a fault is
programmable, see
Set the value required, between 0.0 and 100.0%.
Continued on next page.
is selected at Control Type in the Set
is selected, Position
bndLSS
Millivolt ≤2000mV
Current
Voltage
Resistance
– see page 18.
– see page 18.
for downscale drive.
dN
.
Default Action
for no
NONE