ABB COMMANDER 300 Programming Manual page 37

...4.10 Set Up Control Page
Option
LOGIC1
NONE
AUt MAN
LOCrE M
ACK
F-SPt
P-Strt
P-rSEt
P-SKIP
LOGIC2
NONE
AUt MAN
LOCrE M
ACK
board
OPtION
error
Logic Input Type 1
Refer to Section 4, Figs 4.18 and 4.19 in the Installation
Guide
Select the logic input type for input 1 (must not be the same
as any other logic input type):
If
AUtMAN
Configured Output
LASt
If
F–SPt
see
If
F–SPt
is disabled and the dual set point is the value of one of the
two fixed set points.
Dual set point must be selected (in
Section 4.2) in order to enable the use of the fixed set
points.
If
dUAL
Points Page
Dual selection.
Logic Input Type 2
Refer to Section 4, Figs. 4.18 and 4.19 in the Installation
Guide
Select the logic input type for input 2 (must not be the same
as any other logic input type). The selections and their
actions are as for
frame for details.
1
Continued on next page.
Option Board Disable (not applicable on
COMMANDER 310)
ON
If the Option board fails or is removed, press
to set
this parameter is omitted.
.
– no function available
NONE
– auto/manual
AUtMAN
– local/remote (dual)
LOCrE M
– remote alarm acknowledge
ACK
– fixed dual set point
F-SPt
P-Strt – program start/hold function
– program reset function
P-rSEt
– segment skip function
P-SKIP
is set then the output reverts to the value set in
below, unless configured output is set to
.
is selected two fixed set points are available –
Fixed Dual Set Point 1
is selected, the adjustable dual set point facility
is selected at
the Local/Remote selection becomes Local/
.
Logic Input 1
4 CONFIGURATION...
to . Once set to
OPtION OFF
and
Fixed Dual Set Point 2
Set Points Page
Set Point Type Selection
above – refer to
OFF
below.
–
frame in
Set
Logic Input
35