ABB COMMANDER 300 Programming Manual page 9

...4.2 Set Points Page
To gain access to this and subsequent pages the correct Configuration code must first be set
in the Security Code Page – see Section 5.5 of the Operating Guide .
SEt
POINtS
SP–AdJ
YES
LSP–HI
1000
LSP–LO
0
LSPt
500
SP–trK
no
SPt–SL
YES
Page Header –
Set Points
Set Point Adjustment Enable
This frame allows display and adjustment of the set point in
the
Operating Page Displays
Operating Guide . Select
)
Set Point High Limit
This is the maximum value to which the local set point can
be adjusted.
Set the value required. The decimal point position is set
automatically.
Set Point Low Limit
This is the minimum value to which the local set point can
be adjusted.
Set the value required. The decimal point position is set
automatically.
Local Set Point Value
Set the value required, within the limits set above. The
decimal point position is set automatically to that set in the
Set Up Display Page
Set Point Tracking Enable
If
Set Point Tracking
Manual mode the local set point tracks the process
variable. When the controller is in
the local set point limits can be exceeded. If the local set
point is outside of its limits when the tracking mode is
disabled, the local set point value can only be adjusted
towards its limits. Once within the limits they apply as
normal.
Select to enable or no to disable.
YES
Set Point Select
This frame enables selection of set point type from the
i.e.,
Operating Page
applicable – see
Set Point Type Selection
Operating Guide .
)
Select YES to enable, or no to disable.
Continued on next page.
4 CONFIGURATION...
.
(see Section 5.2 of the
to enable or
YES
– see Section 4.8.
is enabled and the controller is in
Set Point Tracking
,
LOCAL rEMOtE
to disable.
no
mode
, or as
dUAL
( Section 5.2 of the
7