ABB COMMANDER 300 Programming Manual page 12

...4 CONFIGURATION
...4.2 Set Points Page
– – – – – –
– – – – – –
LOCAL
bALNCE
rEMOtE
dUAL
SEt UP
PrCESS
10
Set Point Type Selection
This frame displays the current set point type, or
and value – see
Operating Page
Upper Display – displays the set point type, or
LOCAL
bALNCE
rEMOtE
dUAL
Lower Display – displays the value of the set point type
shown in the upper display, but if the set point type is
changed from Local to Remote (or Dual) the display shows
the difference (
value and the Remote (or Dual) set point value.
When Remote set point is selected and if Remote set point
tracking is enabled the Local set point value tracks the
Remote set point value. The Local set point limits do not
apply in this mode. If the Local set point is outside of its
limits when Local set point type is re-selected, it can only
be adjusted towards its limits. Once within these limits,
they apply as normal.
Press
dUAL
or
selection made at
Return to the top of
page.
or
POStn
F–bACK
Set Point Type Selection
– see Section 5.2 of the Operating Guide .
– Local set point
– Balance, the difference between the
Local and Remote (or Dual) set point
values
– Remote set point on controllers with
Remote set point facility
– Dual set point
bALNCE
to select
LOCAL
). and
rEMOtE dUAL
Second Set Point Type
Set Points Page
or rEGLtr
dAtA
frame in the
) between the Local set point
, ,
bALNCE rEMOtE
are dependent on the
parameter.
or advance to the next
bALNCE
:
bALNCE
(or