Wheel Orientation Information - Snorkel A62JRT Operator's Manual

If this machine has been transported in a container the wheels will have been
flipped to get it into the container. This will make the machine narrower than the
design intent. The machine may be driven with the wheels flipped to load &
unload but only ever when in the stowed position. The machine must not be
used for a job of work until the wheels have been flipped back round to their
Figure 1 – Correct Wheel Orientation
Figure 2 – Wheel Position Decal
The distance between the outer edge of the right wheel
to the outer edge of the left wheel should be 2390mm
(94 in) when the wheels are correctly orientated. Refer
to Figure 3.
A62JRT – 104850-000
WARNING
SAFETY NOTICE
PLEASE READ BEFORE USE
correct position.
180°
To flip the wheel back to the correct orientation (refer to
Figure 1), use the following instructions.
1. Safely jack the machine.
2. Loosen the 9 retaining lug nuts.
3. Safely remove the wheel from the hub.
4. Flip the wheel 180° so that decal 513132-000 is facing
on the inside of the wheel. Refer to Figure 2.
5. Safely fit the wheel back onto the hub.
6. Hand tighten the 9 retaining lug nuts and lower the
machine from the jack.
7. Dry torque the lug nuts to 150 ft lbs in a non-circular
pattern.
WORKING/ELEVATING POSITION
TRANSPORTATION POSITION
Figure 3 – Wheel Position Distance
2190mm
2390mm
3