How To Create/Delete Dialer Group - Siemens FC2005 Programming Manual

19. HOW TO CREATE/DELETE DIALER GROUP

Function: The intend of DialerGroup is to reduce messages reported to supervising station. e.g. If two zones
both detected alarm condition but they are close to each other, sending one piece of alarm message to inform
the supervising station will be enough. On the other hand, the more it reports, the more it costs. The system
need the ability to group zones into dialer groups and reporting is only done by groups, never by the individual
zones. There is one build-in dialer groups that will be created automatically. Newly created zones will be
automatically added to the default dialergroup. Physical devices can not be contained in DialerGroup and
they will be reported as system level messages.
Steps of creating:
1. Press "Menu" to display the main menu (Fig.19-1).
2. Press " " to select "Dialer group" item and press "OK" (Fig.
19-2), dialer group screen is displayed (Fig.19-3).
3. Press "Menu" to display the main menu, press " " to select
"Conf" submenu, to select "Create" and press "OK" (Fig.19-4) ,
create screen is displayed (Fig.19-5). There are two parameters
(type and name) which need to be configured.
4. To select "Type" and press "OK", one default type (dialer group)
is listed (Fig.19-6). Press "OK", the screen returns to the
previous screen and the selected type is shown (Fig.19-7).
5. To select "Name" and press "OK", an input text screen is
displayed. To enter a right name (i.e., "Siemens1) and press
"OK", the screen returns to the previous screen and the new
name is shown (Fig.19-8).
Programming Manual of FC2005/FC901
Fig.19-1
Fig.19-2
Fig.19-3
Fig.19-4
Fig.19-5
Page: 28/48