Modes Menu - NDS ScaleOR User Manual

Modes Menu

The available output modes
the fl button, the tab's legend changes to Modes 0-15 and
the fl button a second time, changes the tab's legend to Modes 16-31 and
displayed. If the fl button is pressed a third time the tab's legend changes to Modes 32-47,
through 46 are displayed.
button a fourth time selects the Picture menu. When the fi button is used to select the Modes tab, the
sequence described above occurs in reverse order. All available output modes are shown in the table on
the following page.
Press the fl button to select the group of
that you want to use.
Press the SCROLL button to highlight the pair of
message
Press the fi or fl button to select the new output mode. The following message appears on bottom of
the OSM.
Press this button to confirm the new output mode. The following message is shown on the bottom of
the OSM.
20 seconds the output mode reverts to the previous output mode.
Press this button to cancel the new output mode. The following message is shown on the bottom of
the OSM.
If the Modes menu appears as shown below, then one or more of the mode switches is turned on, and the
Modes menu is locked. To use the
Output Mode Switches
Note: When the Modes
locked.
are shown when the Modes tab is selected. If the Modes tab is selected using
Mode 47 is not implemented and is shown as None. Finally, pressing the fl
modes
Modes menu turn all of the mode switches off. See page 3 for the
location.
menu is selected, the currently active mode is shown in blue, even if the menu is
modes 0 through 15 are displayed. Pressing
(0-15, 16-31 or 32-47) that contains the output mode
modes that contains the mode to be used. This
appears on the bottom of the OSM.
If the MENU button is not pressed within
modes 16 through 31 are
modes 32
14