Setup Menu - NDS ScaleOR User Manual

Setup Menu

Input Format:
Press the fi or fl button to match the format of the input signal.
Notes:
1. This parameter is not available when a DVI or 3G - SDI input module is installed in the ScaleOR.
2. If this parameter is "grayed" out when the VGA module is installed, then the VGA module has been
preconfigured to accept only the format that appears in blue. To select a different
configure the VGA module to allow the
serial command consult the
3. When the S-Video / Composite module is installed, there are three
Auto*, S-Video, or Composite. When
Composite inputs until a signal is detected. Each input is scanned for approximately five seconds after
which the ScaleOR switches to the other input. When
scanned. The same is true the
58J0079 Rev D and later.
Alternative Mode Tolerance:
This parameter allows the user compensate for input signals whose timing parameters may differ from
those stored in the ScaleOR. Press the fi or fl button to select one of the tolerance parameters. The
Alternative Mode Tolerance
Menu Position:
Places the menu in 1 of 9 predefined screen positions. Press the fi or fl button to select any of the 9
screen positions.
Language:
English only.
DPMS Enable:
Display Power Management System. When
signal is removed, then, if the unit is connected to a monitor, the
for 10 - 15 seconds. After which the ScaleOR goes into standby mode, and turns its outputs off. When an
input signal is applied the ScaleOR comes out of standby and turns its outputs on. Press the fl button to
enable DPMS, press the fi button to disable DPMS.
Menu Lock:
Disables access to menu system. This prevents inadvertent changes to the ScaleOR's settings. To enable
Menu Lock, press the fl button. MENU LOCKED is displayed when the fi button is pressed. To unlock,
simultaneously press and hold the MENU and SCROLL buttons until MENU UNLOCKED is displayed.
Operating Hours: Shows the ScaleOR's hours of operation.
BIOS: Installed version of the ScaleOR's BIOS firmware.
13
Input Format
VGA Module Switches
Auto is selected the ScaleOR switches between the
Composite input is selected. *The
options are available with BIOS 58J0079 Rev D and later.
DPMS
to be selected from the OSM or via an RS-232
table on page 6.
Input Format
S-Video is selected, only the
Auto
is enabled (on), and no input signal is present, or the
"ScaleOR
Input Format, or
parameter options:
S-Video
S-Video
option is available with BIOS
D.P.M.S" message is displayed
and
input is