Assembly And Operation - King Industrial KC-OVS-TL Instruction Manual

Warning! IF ANY PART IS MISSING OR DAMAGED, DO NOT PLUG THE SPIN-
DLE SANDER IN UNTIL YOU HAVE REPLACED THE MISSING OR DAMAGED
PART. For your safety, complete the assembly of the spindle sander before plugging
it into the power supply.
installing tHe on-board storage brackets
1. Mount the drum/spindle on-board storage bracket (A) Fig.3 to either side of the
spindle sander cabinet using 3 cap screws (B). To simplify the assembly, place
the hex. key (C) through the front holes in the bracket to tighten each cap screw.
2. Repeat the above step for the table insert on-board storage bracket (D).
installing eMergencY stop paddle to sWitcH bracket
Make sure the power cord is unplugged from the power source before installing
emergency stop paddle.
1. Install the emergency stop paddle (A) Fig.4 to the switch bracket (B) as shown.
asseMbling sanding spindles and drUMs
1. For 1/4", 1/2", & 5/8" spindles, loosen the screw (A) Fig.5 on the bracket clamp
(B) at the bottom of the spindle.
2. Slide the corresponding sanding sleeve fully onto the spindle. Note: the sanding
sleeve must slide under the bracket clamp (B) Fig.5 as shown. Re-tighten the
screw (A) on the bracket clamp (B) to secure the sanding sleeve. Pull on the
sanding sleeve to make sure it is properly secured to the spindle.
3. For the 1-1/2" and 2" drum, slide the corresponding sanding sleeve onto the
drum. Using the supplied 12mm open end wrench, tighten the nut (A) Fig.6 on
the top of the drum by turning counterclockwise (reverse thread), this will secure
the sanding sleeve. Pull on the sanding sleeve to make sure it is properly se-
cured to the drum, if not tighten nut (A) another 1/2 turn.
asseMblY & operation
FigUre 3
FigUre 4
FigUre 5
FigUre 6