Related Manuals for King Industrial KC-26DS
Summary of Contents for King Industrial KC-26DS
- Page 1 26” X 12” DRUM SANDER MODEL: KC-26DS INSTRUCTION MANUAL COPYRIGHT © 2001 ALL RIGHTS RESERVED BY KING CANADA TOOLS INC.
-
Page 2: Proof Of Purchase
IMPORTANT INFORMATION 2-YEAR KING CANADA TOOLS LIMITED WARRANTY OFFERS A 2-YEAR LIMITED WARANTY FOR THIS 26” DRUM SANDER FOR INDUSTRIAL USE. PROOF OF PURCHASE Please keep your dated proof of purchase for warranty and servicing purposes. REPLACEMENT PARTS Replacement parts for this tool are available at our authorized KING CANADA service centers across Canada. For servicing, contact or return to the retailer where you purchased your product along with your proof of purchase. -
Page 3: General Safety Instructions For Power Tools
GENERAL SAFETY INSTRUCTIONS FOR POWER TOOLS 1. KNOW YOUR TOOL 12. ALWAYS WEAR SAFETY GLASSES. Read and understand the owners manual and labels affixed to Always wear safety glasses (ANSI Z87.1). Everyday the tool. Learn its application and limitations as well as its eyeglasses only have impact resistant lenses, they are NOT specific potential hazards. -
Page 4: Unpacking And Cleanup
YOUR DRUM SANDER UNPACKING AND CLEANUP To ensure maximum performance from your KING CANADA horizontal drum sander KC-26DS , clean it properly; and install it accurately before use. As soon as you receive the sander, we recommend you follow these procedures: 1. -
Page 5: Electrical Connections
ELECTRICAL CONNECTIONS WARNING ALL ELECTRICAL CONNECTIONS MUST BE DONE BY A QUALIFIED ELECTRICIAN. FAILURE TO COMPLY MAY RESULT IN SERIOUS INJURY! ALL ADJUSTMENTS OR REPAIRS MUST BE DONE WITH THE SANDER DISCONNECTED FROM THE POWER SOURCE. FAILURE TO COMPLY MAY RESULT IN SERIOUS INJURY! box. - Page 6 MOUNTING MOUNTING AND REPLACING SANDING BELTS REMOVING THE SANDING BELTS In order to access the sanding drums; lift and tilt the upper guard towards the rear. The sanding belts are fixed at either end of the drums by spring loaded clamps. To Remove The Sanding Belts: - Push the right clamp forward, the tab of the sanding belt must be pulled out of the right drum slot.
- Page 7 ADJUSTMENTS & REPLACING CONVEYOR BELT CONVEYOR BELT TENSION & TRACKING The conveyor belt may slide to the right or left during operations, or the tension of the conveyor belt is too loose or too tight. To adjust follow these procedures: - Turn the adjustment bolts on either side of the conveyor table.
-
Page 8: Sanding Operations
SANDING OPERATIONS & MAINTENANCE SANDING OPERATIONS Always start the dust collector before turning on the sander. Press the green "ON" button on the control box to start the machine. Key switch must be engaged to start running the conveyor belt. Position the conveyor speed adjustment knob to the required stock feed.
Need help?
Do you have a question about the KC-26DS and is the answer not in the manual?
Questions and answers