Maintenance; Adjustment Of The Quick-Fastener; Disposal; Contact - pro user DIAMANT SG3 Operating Instructions Manual

Maintenance / Disposal / Contact

Maintenance

Check the bicycle carrier for wear before the start of every
journey. Defective metal parts and straps in particular must
be replaced.
Please refer to our customer service for the replacement
of parts.
Any modification of original parts and materials or the
construction of bicycle carrier can adversely affect its
safety and serviceability.
The steel parts of the bicycle carrier are protected in the
works against corrosion by a powder-paint coating. If this
paint coating is damaged, please have the damage
rectified professionally as soon as possible.
Under normal conditions and use, the bicycle carrier only
requires cleaning, and is otherwise maintenance-free.

Adjustment of the quick-fastener

Carry out this maintenance operation only if the bicycle
carrier cannot be fitted firmly to the trailer coupling, as
described in the chapter "Fitting".
• Remove the bicycle carrier from the trailer coupling, as
described under "Dismantling".
• Remove the dust protection cap.
• Loosen the locking nut slightly, as shown in the
illustration.
• Screw in the setting screw one quarter of a turn.
• Tighten the locking nut.
• Check whether the carrier is now firmly seated on the
trailer coupling, as described under "Fitting". If not,
repeat the above steps.
76

Disposal

Local regulations must be observed for the disposal of the
product.
The packaging should also be sorted by type and
disposed of in the relevant collection containers.
Further information is available from your communal
disposal point.

Contact

Tradekar Benelux BV
Staalweg 8
4104 AT CULEMBORG
Nederland
Telephone: +31 (0)345 470 990
Telefax: +31 (0)345 470 991
E-mail: info@tradekar.nl
Consumer helpdesk & support
Telephone: +31 (0) 345-470998
(Monday till Thursday 8:30-12:30)
E-mail: service@tradekar.nl