Basic Recording - Aiwa NSX-V50 Operating Instructions Manual

1
I
l'>
3
DOLBY NR
UNR
I
5
REC/
y
REC MUTE
BASIC RECORDING
This section explains how to record from the tuner, CDs, or
external equipment. On recording from tapes, see pages 38 to
40.
Preparation
Wind up the tape to the point where recording will start.
Use normal (type I) and CrOp (type 11)tapes for recording.
1
2
3
4
5
Insert the tape to be recorded on into deck 2.
Insert the tape with the side to be recorded first facing
the foreground and the exposed
side down.
Press the REV MODE button to select the reverse
mode.
To record on one side only, turn on =.
To record on both sides, turn on ~> or (~).
Press the DOLBY
NR button to turn Dolby NR on
or off.
To recordwith
DOLBY NR, turn on 00 NR.
To record without DOLBY NR, turn off !30 NR.
Press one of the function buttons and prepare
the source to be recorded.
To record from a CD, pressthe CD buttonand load tt?e
disc(s),
To record from a radio broadcast, press the TUNER button
and tune in to a station.
To record from the connected source, press the VIDEO/
AUX button and play.
Press the REC/REC MUTE button to start
recording.
When the selectedfunctionis CD, playbackand recording
startsimultaneously.
To stop recording, press the E button.
To pause recording, press the II button. (Applicable when the
source is TUNER, VIDEO/AUX.) To resume recording, press
again.
To start recording with the remote control
Firstpressthe /0 REC/RECMUTE button, a ndthen
press the
<> button within 2 seconds.
INSERTING BLANK SPACES
Insertion of 4-second blank spaces enables activation of the,
Music Sensor function. (Applicable when the source is TUNER
or VIDEO/AUX.)
1 Press the REC/REC MUTE button during recording or
while in recording pause mode.
~ on the display flashes for
4
seconds and the tape runs
without recording. After 4 seconds, the deck enters the
recording pause mode.
2 Press the II button to resume recording.
To insert a blank space of less than 4 seconds, press the
REC/REC MUTE button again while ~ is flashing.
To
insert blank
spaces of more than 4 seconds, after the
deck enters recording pause mode, press the REC/REC MUTE
button again. Each time the button is pressed, a 4-second blank
space is added.
36