Continuous Play - Aiwa NSX-V50 Operating Instructions Manual

BASIC OPERATIONS
MUSIC SENSOR
If there is a 4-second or longer blank between each track, the
search for the beginning of the current or next track during
playback can be easily made.
When the F of the 4P button is illuminated,
press the *
button to move to the next track or the 44 button to move to the
beginning of the current track.
When the 4 of the <k button is illuminated, press the -
button to move to the next track, or the * button to move to
the beginning of the current track.
The search function uses a music sensor that may not be able
to detect t racks for tapes with:
blanks of less than 4 seconds between tracks.
noisy blanks.
long passages of low-end sound.
low overall recording levels.
CONTINUOUS PLAY
After playback on one deck finishes, the tape in the other deck
will start to play without interruption.
1
2
3
4
—
Insert tapes into decks 1 and 2.
Press the TAPE/DECKl/2 button to select the
deck to be played back first.
Press the REV MODE button to select ~>.
Press the > button to start playback.
Playback continues until the button is pressed.
About cassette tapes
To prevent accidental erasure, break off the plastic tabs on
the cassette tape after recording with a screwdriver or other
pointed tool. ~
@ Side Al@ Tab for side A
To record on the tape again, cover the tab openings with
cellophane tape, etc. (On CrOz tapes, take care not to cover
the CrOz tape detection slot @.)
120-minute or longer tapes are extremely thin and easily
deformed or damaged. They are not recommended.
Take up any slack in the tape with a pencil or similar tool before
use. Slack tape may break or jam in the mechanism.
+E
DOLBY NR system
The Dolby Noise Reduction system reduces tape hiss noise.
For optimum performance when playing back a tape recorded
with the DOLBY NR system, turn on the DOLBY NR system.
34