Char-Broil GRILL2GO X200 Product Manual page 7

DANGER
• NEVER store a spare container under or near the
appliance or in an enclosed area.
• Never fill a container beyond 80% full.
• An overfilled or improperly stored cyclinder is a hazard
due to possible gas release from the safety relief valve.
This could cause an intense fire with risk of property
damage, serious injury or death.
• If you see, smell or hear gas escaping, immediately get
away from the LP container/appliance and call your fire
department.
Safety Tips
• The use of alcohol, prescription or nonprescription drugs
may impair the consumer's ability to properly assemble or
safely operate the barbecue.
• When barbecue is not in use, disconnect 465g container.
• Never move barbecue while in operation or still hot. Allow the
barbecue to cool before moving or storing.
• The regulator may make a humming or whistling noise
during operation. This will not affect safety or use of barbecue.
• If you have a barbecue problem see the Troubleshooting Section.
• Light burner. Check to make sure it is lit, close the lid
and warm up barbecue on high for 10 minutes. Curing of paint
and parts will produce an odour only on first lighting.
• barbecue is not to be used as a heater.
• This barbecue will be hot during and after use. Use insulated
oven mitts or gloves for protection from hot surfaces or
splatter from cooking liquids.
• Clean barbecue often, preferably after each cookout. If a bristle
brush is used to clean any of the barbecue cooking surfaces,
ensure no loose bristles remain on cooking surfaces prior to
barbecueing. It is not recommended to clean cooking surfaces
while barbecue is hot.
Ignitor Lighting
READ INSTRUCTIONS BEFORE LIGHTING.
Do NOT lean over barbecue while lighting.
1. Turn gas regulator control knob to
2. Connect LP gas container.
3. Open the barbecue lid.
4. Press and turn the control knob to the
ignitor button rapidly.
5. Once the burner has ignited, turn the regulator control knob to
the desired setting.
6. If ignition does not occur in 5 seconds, turn the regulator
control knob to , wait 5 minutes, and repeat lighting
procedure.
If ignition still does not occur, follow match-lighting
instructions.
.
position. Push
CAUTION
If ignition does NOT occur in 5 seconds, turn the
regulator control knob to
repeat the lighting procedure. If the burner does not
ignite with the regulator control knob open, gas will
continue to flow out of the burner and could
accidently ignite with risk of injury.
Match Lighting
1. Insert lit match into match hole in barbecue end, next to burner.
Turn regulator control knob to setting .
2. If ignition does NOT occur in 5 seconds, turn the regulator
control knob to , wait 5 minutes and repeat the lighting
procedure.
Match Light Hole
Turning barbecue Off
Turn control knob to position. Disconnect LP container.
Burner Flame Check
• Light burner. Looking through the match light hole, end of barbecue,
you should see the flame height as shown below. Turn control knob
from position HIGH to LOW. The Flame height should decrease.
Always check flame prior to each use. If only low flame is seen refer
to "Low flame, drop in gas flow" in the Troubleshooting Section.
Ignitor Check
• Remove LP container.
each time at electrode. See "Troubleshooting" if no click or spark.
, wait 5 minutes and
High Flame
Low Flame
Push ignitor button. "Click" should be heard
Page 7